Reply to thread

I promise I didn’t forget about this project, as a nursing student sometimes you just get busy. I finally started printing the helmet today, 1 quarter is down with 3 left, and I already have the visor taken care of. Got it in a nice chrome finish, and while I’ve been too busy to deal with a large project like the odst, I did do some smaller prints in the meantime like another magnum and some starwars props to hang up on my wall. Helmet should be all glued together by the end of the month, with the rest of the armor soon to follow. Updates coming!


This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top