Cortana’s Chip


SpartanIIGaming

New Member
Just bought an Ender 3. After learning the basics and dialing in settings, I decided my first print was gonna be Cortana’s Chip. I think it’s decent for my first print ever but I’m gonna clean it up, paint it and weather it. A few more tests and I’ll start printing some armor out on this bad boy.
4863935D-BEA7-4219-975F-0E8754B086F9.jpeg
 

CortexZerks

New Member
This is awesome, I was at a con and a master chief was handing out chips to people he met, it was amazing.
Keen to see how you get to use this 3d printer in the future, always great to get a full suit going ;-)
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top