I recently acquired a CQB MKVI helmet and after a lot of researching I discovered no one had a template to help modify a visor to be a little more accurate to the game design.
I used what references I could and fit it best per how I liked it.
The file was created using Adobe Illustrator and then manipulated to make it fit on a BILT Full Face Shield. It should fit easily onto a piece of 8.5x11 card stock or piece of paper so you can test fit it yourself to see.
My file can be used to either cut the template ontop of a sheet of flex film or to stick onto your visor, cut your visor to the template and lay flex film underneath to give it a 3D pop. I hope you guys enjoy!
I used what references I could and fit it best per how I liked it.
The file was created using Adobe Illustrator and then manipulated to make it fit on a BILT Full Face Shield. It should fit easily onto a piece of 8.5x11 card stock or piece of paper so you can test fit it yourself to see.
My file can be used to either cut the template ontop of a sheet of flex film or to stick onto your visor, cut your visor to the template and lay flex film underneath to give it a 3D pop. I hope you guys enjoy!