Reply to thread

Message

Alright... update time.

Last helmet panel printed after about a week of trial and error. Long story short, it is a minimum 30 hour print when using PLA for a support interface layer for my PETG prints. And I spent a lot of time working on settings for supports since they kept failing. But success. And it fits. Detail pieces printing now.

I hope to start printing the first chest panel tonight. Armorsmith shows that it'll fit, but I don't fully trust that yet. We'll see.

Fresh off printer, pre-cleanup photos below.

[ATTACH=full]339990[/ATTACH][ATTACH=full]339991[/ATTACH]
[ATTACH=full]339992[/ATTACH]
[ATTACH=full]339993[/ATTACH]

[QUOTE="Farris, post: 835028, member: 2820"] Alright... update time. Last helmet panel printed after about a week of trial and error. Long story short, it is a minimum 30 hour print when using PLA for a support interface layer for my PETG prints. And I spent a lot of time working on settings for supports since they kept failing. But success. And it fits. Detail pieces printing now. I hope to start printing the first chest panel tonight. Armorsmith shows that it'll fit, but I don't fully trust that yet. We'll see. Fresh off printer, pre-cleanup photos below. [ATTACH type="full"]339990[/ATTACH][ATTACH type="full"]339991[/ATTACH] [ATTACH type="full"]339992[/ATTACH] [ATTACH type="full"]339993[/ATTACH] [/QUOTE]

This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification