Logging an initial decision before I forget:
I want to print the boot soles in TPU, or some other similar rubbery filament. I have time and the printer can handle it. It should be easier to walk on/have better traction/be more durable than just straight petg. On my last suit, I just cut a rubber horse mat with a box cutter. It was a giant pain in the butt, but it worked. The only "bad" decision I made on the boots of my old suit was using combat boots inside the costume boot. Those made it difficult to get the suit on/off.
Otherwise, prints are still going. No catastrophes with the last 2 pieces. Should have the last section for piecing the top of one side of the chest to top of one side of the back off the printer this afternoon.
