Reply to thread

Message

I'm finally reaching the end of this print. First boot is printed and 2nd boot will be done tonight.

My only concern at this point is that I intended on putting a shoe inside the boot. However, the length and width does not seem large enough since my foot is taking up almost all of the space. Perhaps something thinner than I planned will work. I attempted to get it pulled together get a picture of what I'm describing, but didn't feel like taping things so that fell apart. There's plenty of height, so maybe my foot is just in the wrong spot.

But pictures of the boot! Apologies for the disaster of a workbench. I'll clean it up tomorrow.

[ATTACH]350828[/ATTACH][ATTACH]350829[/ATTACH][ATTACH]350830[/ATTACH]

[QUOTE="Farris, post: 846841, member: 2820"] I'm finally reaching the end of this print. First boot is printed and 2nd boot will be done tonight. My only concern at this point is that I intended on putting a shoe inside the boot. However, the length and width does not seem large enough since my foot is taking up almost all of the space. Perhaps something thinner than I planned will work. I attempted to get it pulled together get a picture of what I'm describing, but didn't feel like taping things so that fell apart. There's plenty of height, so maybe my foot is just in the wrong spot. But pictures of the boot! Apologies for the disaster of a workbench. I'll clean it up tomorrow. [ATTACH]350828[/ATTACH][ATTACH]350829[/ATTACH][ATTACH]350830[/ATTACH] [/QUOTE]

This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification