Reply to thread

Message

Progress is being made. Almost everything is assembled and all but one shin and the codpiece have their first base coat of paint.

Most parts are a tight fit but livable, but the codpiece was way too tight So I scaled it up 6% and it will be done printing tonight.

Picture of most parts before I got the first base coat on all of them. It's pretty humid so I'm giving the parts until tomorrow to finish curing before I mask for the green.

Hope to be able to spend next weekend weathering and strapping.

[ATTACH]351296[/ATTACH]

[QUOTE="Farris, post: 847245, member: 2820"] Progress is being made. Almost everything is assembled and all but one shin and the codpiece have their first base coat of paint. Most parts are a tight fit but livable, but the codpiece was way too tight So I scaled it up 6% and it will be done printing tonight. Picture of most parts before I got the first base coat on all of them. It's pretty humid so I'm giving the parts until tomorrow to finish curing before I mask for the green. Hope to be able to spend next weekend weathering and strapping. [ATTACH]351296[/ATTACH] [/QUOTE]

This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification