Reply to thread

This might not be the right place to ask this, but I was wondering how you managed to scale your vambraces. I have printed 2 so far, as I have very lanky and long forearms and large hands, meaning that I can't fit my hands through the wrist section of my vambrace if I make it fit snugly on my forearm, any suggestions?


This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top