Reply to thread

I thank you for your advice. In addition, however, I think that I neglected to give the the print orientation. The model was printed with the wrist opening face down on the build plate. The weird texture is not present on a top/bottom  surface like you may expect, but on a side wall. I think it may be something called "salmon skin", but I am not certain, as that would indicate a printer hardware problem. What do you think of such?


This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top