Reply to thread

Ohhhh got it. I’ve seen the similar pattern on some of my prints, but it was always as the print rose up. Not sure about it being on the side. My original advice still stands though that sanding should probably fix it for you, assuming your walls are thick enough. Hard to see how tall the ridges are.


This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top