1st Build First 3D Printed Armor! - HALO: INFINITE


FLEX TAPE

Jr Member
THE HELMET IS PRINTING!!! The print didn't stick well at the top part of the helmet so it had a whole section that is messed up and not smooth but I didnt see that until recently so I'm just going to let it finish and use some bondo or wood filler to fix the problem area. Should look pretty good besides that!
 

Attachments

  • 20210426_151917.jpg
    20210426_151917.jpg
    1.5 MB · Views: 22
  • 20210426_080836.jpg
    20210426_080836.jpg
    2.9 MB · Views: 27

FLEX TAPE

Jr Member
Ok heres an update on the helmet! The wood filler has been applied and I have almost finished the paint job!
 

Attachments

  • 20210506_165755.jpg
    20210506_165755.jpg
    1.5 MB · Views: 19
  • 20210508_101257.jpg
    20210508_101257.jpg
    2.1 MB · Views: 13
  • 20210508_121624.jpg
    20210508_121624.jpg
    1.9 MB · Views: 15
  • 20210509_200112.jpg
    20210509_200112.jpg
    1.5 MB · Views: 14
  • 20210510_121432.jpg
    20210510_121432.jpg
    1.8 MB · Views: 13
  • 20210510_124648.jpg
    20210510_124648.jpg
    1.2 MB · Views: 14
  • 20210510_124657.jpg
    20210510_124657.jpg
    1.5 MB · Views: 15
  • 20210510_124701.jpg
    20210510_124701.jpg
    1.4 MB · Views: 21

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top