Reply to thread

Progress update, finished up the legs.

Again 3d printed from the files mentioned before.

Painted, weathered, and then added some foam in the thighs and shins so they wouldn't spin/slide around.


To hold the pieces in place I created a "carrier" to hold the weight and to keep the armor pieces from sliding down.

Made of 1" Nylon webbing and buckles from Amazon.

I took some rough measurements for my body and then added around 6" because it is made to be adjustable.

I then hand sewed the webbing together for proper strength.


The pieces attach with buckles as follows:

Carrier -> thighs -> shins


Each piece can be separated for easier storage/transportation.

And as mentioned, each piece has the ability to be independently height adjusted.


Hoping to finish in time for DragonCon2024.


This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top