Reply to thread

Small update.

Finished the hands.


I found some cheap gloves on Amazon that had a type of "armored" look to them.

After a quick print of the hand pieces, I hot glued them to the gloves; we'll see how they hold up.

As simple as that.


I have the pieces for the boots printed, just gotta figure out how to rig them up.

Hope to get them finished this weekend.


This thread is more than 9 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top