Reply to thread

Message

[ATTACH=full]359884[/ATTACH][ATTACH=full]359888[/ATTACH]
[ATTACH=full]359887[/ATTACH]
Busy couple days. Tragedy struck the other day and my son dropped and cracked Mnkr’s halo 3 marine helmet that ive been borrowing/using since i didnt have a suit, knocking it out of commission for C2E2 and forcing me to use my patrol cap this year(which led to me printing the unsc logo for it(i think it was Fallen’s Model on thingiverse iirc in which case thank you!)) I felt so bad about the helmet that i printed & springed up the black m6c pictured above for him. (Which turned out way better than mine and im probably reprinting a good chunk of mine with the lessons learned so far)

I also sanded and primed the helmet over the weekend and printed out my shinguards and knee caps over the past 2 days.

Any guidance/tips on sizing the boot pieces would be greatly appreciated as i plan on tackling those next!

<blockquote data-quote="Wing" data-source="post: 855400" data-attributes="member: 58963">[ATTACH=full]359884[/ATTACH][ATTACH=full]359888[/ATTACH][ATTACH=full]359887[/ATTACH]Busy couple days. Tragedy struck the other day and my son dropped and cracked Mnkr’s halo 3 marine helmet that ive been borrowing/using since i didnt have a suit, knocking it out of commission for C2E2 and forcing me to use my patrol cap this year(which led to me printing the unsc logo for it(i think it was Fallen’s Model on thingiverse iirc in which case thank you!)) I felt so bad about the helmet that i printed &amp; springed up the black m6c pictured above for him. (Which turned out way better than mine and im probably reprinting a good chunk of mine with the lessons learned so far)I also sanded and primed the helmet over the weekend and printed out my shinguards and knee caps over the past 2 days.Any guidance/tips on sizing the boot pieces would be greatly appreciated as i plan on tackling those next!</blockquote>

[QUOTE="Wing, post: 855400, member: 58963"] [ATTACH type="full"]359884[/ATTACH][ATTACH type="full"]359888[/ATTACH] [ATTACH type="full"]359887[/ATTACH] Busy couple days. Tragedy struck the other day and my son dropped and cracked Mnkr’s halo 3 marine helmet that ive been borrowing/using since i didnt have a suit, knocking it out of commission for C2E2 and forcing me to use my patrol cap this year(which led to me printing the unsc logo for it(i think it was Fallen’s Model on thingiverse iirc in which case thank you!)) I felt so bad about the helmet that i printed & springed up the black m6c pictured above for him. (Which turned out way better than mine and im probably reprinting a good chunk of mine with the lessons learned so far) I also sanded and primed the helmet over the weekend and printed out my shinguards and knee caps over the past 2 days. Any guidance/tips on sizing the boot pieces would be greatly appreciated as i plan on tackling those next! [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification