Reply to thread

To me, Those seams look solid. But, I'm still working on my first build.


I have 95% of the parts printed and I began assembling. Glue, Epoxy, Welding, and I will go back and add some hot staples in a few places for good measure.


The good: Welding is easier than I expected

The Bad: I have a lot of parts that could have been printed at one piece. Like the Front Chest. One of the breast plates could have been included with the Main underbody & the sleeve gasket. The other breast plate with the front collar and another gasket part. That would be 6 parts printed at 2 parts, assembled with a long complex, easy to brace, seam.


It's all part of the process.


Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top