First odst helmet

Discussion in 'Halo Costumes and Armor' started by Deltaodst, Nov 30, 2018.

  1. Deltaodst

    Deltaodst New Member

    Trophy Points:
    Hello all just almost done my first odst helmet form eva foam using andrew dft templates not the best build i would think. IMG_20181201_001358~2.jpg
  2. TurboCharizard

    TurboCharizard RMO & BCO 405th Regiment Officer Community Staff

    Trophy Points:
    It's not a bad start!

    If you ever need any help or ideas on how to improve on your techniques, the gang here on the forums is really helpful! I'd say this helmet is a really good first build but you're falling into the same trap I did way back when and used far too much hot glue. If you use enough so that it sticks but not squeeze out the outward facing edge you'll have an easier time sanding and cleaning up edges later on.

    Keep up the good work and I can't wait to see the finished suit!

Share This Page