Free 3D Model Index

tahu505

Active Member
Finally got around to updating my tacpad. fixed some of the details where the green lights go and changed the screw size. I updated my thingiverse page for it so the link at the front of this thread will still take you to the new one.
tacpadv2.PNG

tacpadv2_back.PNG
 
I blame you and your gorgeous files for this one :lol:
Added zinc rods for support, magnetized middle section to break down into a suitcase and made a bit of room for a battery and arduino. Gorgeous files here thank you for posting them! I did notice that there were minimal/no tolerances on the parts that fit together so I had to do a decent bit of sanding on that end, a small price to pay.

View attachment 321793
Finished!!! Picture dump incoming....
20220815_095319.jpg
20220815_095325.jpg
20220815_095334.jpg
20220815_095340.jpg
I used neodymium magnets to make the floaty bits movable.
20220815_095434.jpg
20220815_095438.jpg
20220815_095444.jpg
20220815_095453.jpg
Halo 4 Version
20220815_100152.jpg
20220815_100158.jpg
20220815_100202.jpg
Halo 5 Version
20220815_100300.jpg
20220815_100307.jpg
20220815_100312.jpg
 

Rock Lobbster

Well-Known Member
Stream Team
Member DIN
S098
James wanted a TAC/MAT model, I had a free hour or so... here we are!
File has not been tested for printing yet, please let me know if any issues are encountered while printing. Comes with communicator, hard-shell upper and lower.
As always this is a non commercial file, personal use only! (CC-BY-NC)

Enjoy!

Screenshot 2022-08-26 231546.png
image (5).jpg
image (6).jpg
 

Attachments

  • TACMAT 2519.zip
    280.2 KB · Views: 40

James

BXO
405th Regiment Officer
James wanted a TAC/MAT model, I had a free hour or so... here we are!
File has not been tested for printing yet, please let me know if any issues are encountered while printing. Comes with communicator, hard-shell upper and lower.
As always this is a non commercial file, personal use only! (CC-BY-NC)

Enjoy!

View attachment 322249 View attachment 322247 View attachment 322251
You are the absolute best. I'll be printing this very soon, so I'll let you know how it goes
 

Wayward Flood

Member
I made the Lehto 20th anniversary MkV Helmet for 3D printing. It's about 6 .4mm walls thick at a .2 layer height. The odd geometry is removed from being solidified in Blender. The zip has 3 files with the visor that I haven't sized down for a vacuum form buck.

I should add that this is currently sized to fit my head with it just barely being able to touch my ears.

1665020551406.png
20221005_224524.jpg
 

Attachments

  • Lehto MkV Helmet .zip
    807.1 KB · Views: 24
Last edited:

Your message may be considered spam for the following reasons:

Top