Reply to thread

I'm looking into making my very own MK VII Armor core (I already have the printer and have started working on a weapon while I figure out the armor) I was wondering what 3d programs out there are good for the scaling part of this. I'm using measurements of my body along with a 3d scan from a phone for reference. What programs would you recommend?


This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top