Halo 4 mark v shoulder piece

Status
Not open for further replies.

Gizinski117

New Member
so the halo 4 shoulder piyseens to to be the right size. But the width seems to be off there is a part in the back/inside that i could cut and but velcro. If i were to do that how would i do it since this is my first suit. In the pictures you see it to wide but the depth is fine. What could i do to correct this?
IMG_4742.JPG
IMG_4743.JPG
IMG_4744.JPG
IMG_4745.JPG
 
If they are too wide just cut out a section of them while they are still paper. Somewhere least noticeable. Then take a strip of card stock and glue it on the inside like a band aid, or self made tab.

Good job with the pepping!
 
Actually I wouldn't cut a section away. Find that least noticeable area that PerniciousDuke mentioned and just overlap the ends till it fits you properly. Mark it off and then you can glue together.
 
Status
Not open for further replies.
Back
Top