lincoln almighty
New Member
So, after scouring the internet for the Chief's Halo 4 armor Pepakura files unfolded and modded for use with foam and coming up with zilch, I decided to take it upon myself to fix them up.
I found a stash of the Chief's armor for use with cardstock, and I've started work on fixing them up. So far I've done the hand plates, the bicep piece, ab plate, and I've begun work on the chest and cod piece.
I'll be posting them here bit by bit as they're done (for some reason I'm not able to post in the "Creation Discussion" Forums, even though I've been a member for a few years now).
I've never really done this kind of work before, but I know the basics. Ditch all high-def, fiddly little parts. Break all sharp, angled folds, and only include one of every symmetrical piece. But I was wondering if there were any helpful hints or any advice anyone could throw me (for your benefit really).
Also, I've never had to upload files onto the 405th before, so could somebody let me know how to do this also?
Thanks guys.
I found a stash of the Chief's armor for use with cardstock, and I've started work on fixing them up. So far I've done the hand plates, the bicep piece, ab plate, and I've begun work on the chest and cod piece.
I'll be posting them here bit by bit as they're done (for some reason I'm not able to post in the "Creation Discussion" Forums, even though I've been a member for a few years now).
I've never really done this kind of work before, but I know the basics. Ditch all high-def, fiddly little parts. Break all sharp, angled folds, and only include one of every symmetrical piece. But I was wondering if there were any helpful hints or any advice anyone could throw me (for your benefit really).
Also, I've never had to upload files onto the 405th before, so could somebody let me know how to do this also?
Thanks guys.