Halo 5 Centurion foam build [and possibly 3d printed]

Dirtdives

RXO & Keeper of Con Lists
405th Regiment Officer
Community Staff
You might think about putting the phone holder right inside the collar section or right in front at the throat shield. Either area you might get a glimpse at the phone's face if you just glance down....
 

Rinzlerr

Jr Member
You might think about putting the phone holder right inside the collar section or right in front at the throat shield. Either area you might get a glimpse at the phone's face if you just glance down....
I do have room for that. Had to adjust the shoulder height two times to accommodate the helmet
 
Last edited:

Sean Anwalt

RCO
405th Regiment Officer
I'd also recommend putting the phone in the front. It will be super hard to deal with in the back.

I'm liking your foam work so far. Your seams look decent, just a little filler work to do once everything is all settled.

Keep up the great work and remember to keep us posted!
 

Rinzlerr

Jr Member
I'd also recommend putting the phone in the front. It will be super hard to deal with in the back.

I'm liking your foam work so far. Your seams look decent, just a little filler work to do once everything is all settled.

Keep up the great work and remember to keep us posted!
was thinking molle style but i'm not sure how I would go about attaching it since I have camera equipment
 

Dirtdives

RXO & Keeper of Con Lists
405th Regiment Officer
Community Staff
Say hypothetically a bungee cord got stuck in my tire and caused a lot of little dents at once, how does that work out?
In this case, it just equates to you being a very bad driver..........:D

I've had so many photoshoots inbetween the build. almost seems like I need to save for a 3d printer or something lol
Then it becomes a contention between dealing w/ dents or a ton of sanding...........
giphy-downsized.gif
 

Rinzlerr

Jr Member
not happy with the limbs right now so i'm putting the project on hold till I buy a 3d printer
 
Top