Halo 5 Centurion foam build [and possibly 3d printed]

Status
Not open for further replies.

Rinzlerr

BXO
405th Regiment Officer
okay guess this is a first time build thread. been slowly working on this the last few months
forming the chestpiece
20190122_000452.jpg 20190121_200716.jpg 20190121_171306.jpg
more revisions and test fitting
20190125_011334.jpg 20190127_151407.jpg 20190127_151413.jpg 20190129_203747.jpg 20190129_203826.jpg 20190130_143428.jpg20190124_220429.jpg
more details
20190130_143450.jpg 20190130_143438.jpg 20190130_143433.jpg 20190130_143428.jpg

reference material
GpxFgAy.jpg

rYD9RSY.jpg


camera puns aside shooting for T3 with this build
 

Attachments

  • 20190122_105824.jpg
    20190122_105824.jpg
    670.1 KB · Views: 364
Last edited:
You might think about putting the phone holder right inside the collar section or right in front at the throat shield. Either area you might get a glimpse at the phone's face if you just glance down....
 
You might think about putting the phone holder right inside the collar section or right in front at the throat shield. Either area you might get a glimpse at the phone's face if you just glance down....
I do have room for that. Had to adjust the shoulder height two times to accommodate the helmet
 
Last edited:
I'd also recommend putting the phone in the front. It will be super hard to deal with in the back.

I'm liking your foam work so far. Your seams look decent, just a little filler work to do once everything is all settled.

Keep up the great work and remember to keep us posted!
 
I'd also recommend putting the phone in the front. It will be super hard to deal with in the back.

I'm liking your foam work so far. Your seams look decent, just a little filler work to do once everything is all settled.

Keep up the great work and remember to keep us posted!
was thinking molle style but i'm not sure how I would go about attaching it since I have camera equipment
 
Finally made another dent in it today
 

Attachments

  • 20190318_222617.jpg
    20190318_222617.jpg
    1.5 MB · Views: 299
  • 20190318_204950.jpg
    20190318_204950.jpg
    1.2 MB · Views: 329
  • 20190318_205006.jpg
    20190318_205006.jpg
    1.1 MB · Views: 296
  • 20190318_222610.jpg
    20190318_222610.jpg
    1.6 MB · Views: 304
  • 20190318_222613.jpg
    20190318_222613.jpg
    1.4 MB · Views: 290
Say hypothetically a bungee cord got stuck in my tire and caused a lot of little dents at once, how does that work out?
In this case, it just equates to you being a very bad driver..........:D

I've had so many photoshoots inbetween the build. almost seems like I need to save for a 3d printer or something lol
Then it becomes a contention between dealing w/ dents or a ton of sanding...........
giphy-downsized.gif
 
not happy with the limbs right now so i'm putting the project on hold till I buy a 3d printer
 
Status
Not open for further replies.
Back
Top