Halo Reach MKV Build

Status
Not open for further replies.

BobRossIsMaDad

Member
Here’s my Reach MKV build so far! Planning on making most of this build out of foam and have some 3D printed pieces too!
Using the pepakura file
Material is 6mm foam
 
Here’s my Reach MKV build so far! Planning on making most of this build out of foam and have some 3D printed pieces too!
Using the pepakura file
Material is 6mm foam
Thighs
1EE97CAA-F591-4013-8D46-D37210D94AD8.jpeg
 
Here’s my Reach MKV build so far! Planning on making most of this build out of foam and have some 3D printed pieces too!
Using the pepakura file
Material is 6mm foam
So I have two different hand plate designs here.

One is from the MCC files and the other one is from an old suit.

Which set of plates should I use for my reach armor?
2C49FA25-B62A-473B-B452-83507EA33A9C.jpeg
 
I decided to leave the lower half open just out of preference. I’ll probably make a little piece that’ll hand off the back via elastic strapping
 
Status
Not open for further replies.
Back
Top