Props Halo Reach Needle rifle (3d Printed)

PA Cosplay

New Member
Now that I've gotten my Br-55 done, its time to move onto the next project. I've been printing this for a good week and a half so far but I still got quite a bit to print to go. The file is on thingerverse by OddWorks, I'm printing at 130% size to make it feel like something only an elite could use. ill keep y'all posted as the prints continue.
 

Attachments

  • 20201209_155841.jpg
    20201209_155841.jpg
    2.8 MB · Views: 318
This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top