Halo Reach Security Helmet

Status
Not open for further replies.

Benton188

RCO
Member DIN
S188
Thought it was due time I made a quick post about a special helmet I made via the pepakura method. Now I know it looks a little bumpy/edgy on the outside, but that's my personal preference. I like the look of the sharp edges on the outside, it gives it a more polygonal feel to it, like it's out of an older game.......plus I don't like to do bondo all that much lol. That being said, I present to you a helmet that isn't done all too often in this community and my personal favorite helmet of all time: Reach Security Helmet:
12289716_709351589201190_3555371746132888858_n.jpg

Still working on the visor portion, the visor buck attachment, and the side little missile pod attachment thing, but I'll post another finished pic once those are ready and attached. Hope you like it :)
 
Heck ya I like it! We're supposed to build what we like right? Some people like smooth and polished, and some like hard and rustic. I think it's a cool helmet and good on you for building on that we don't see very often.
 
Very cool! That's the helmet I'm going to go for when I do my Reach build. It does look challenging, especially the visor. I'd be curious what you end up doing for the visor. Nice job.
 
Finally got around to putting the visor in. After lots of trial and error with different methods I ended up just going with some window tint film. It got wavy and stuff do to all the odd angles of the helmet, but I don't mind it cause I got the effect of the visor bulging out which is what I wanted most. Next I'm going to put on the visor attachment, and maybe even a Go-Pro on the side.
12745708_1268361299844364_3957327961394737466_n.jpg 12745902_1268361326511028_6178603396988190993_n.jpg
 
Status
Not open for further replies.
Back
Top