Reply to thread

Final diffuser updates and hollowing for light channels in place. Have filament and another printer on the way to hopefully start test printing everything next week. Just finished scaling it to the game accurate size of 40", but will be printing mine at 90% scale to keep in line with my Jun ratio to actual lore.

[ATTACH=full]354571[/ATTACH]


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top