Reply to thread

Hey all!

Not really got much of an update on this one, you know when life gets busy and things have to go on hold for a little while, so been going what i can in the meantime to finish off all the printing and get the little bits done before i can really spend some time beginning the finishing process.


Managed to get the SMG printed though! Which is nice (Galactic Armory Files) and just need to finish off printing smaller details and boot covers and we're there!


Will hopefully find some time soon though to really hammer out the sanding and primer process!


Thanks again for taking a look :)


[ATTACH=full]346816[/ATTACH] [ATTACH=full]346817[/ATTACH]


[ATTACH=full]346818[/ATTACH]  [ATTACH=full]346819[/ATTACH]

[ATTACH=full]346820[/ATTACH]


This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top