Help With ODST Pep.

[TillXValhalla]

This may be a Noob question and im sure its covered somewhere, Somewhere i have not been able to find despite searching but if i were to use the ODST Dutch pep file what would i have to do to the scaling? I only ask instead of trial and error as im trying to have this done by June 15th for Denver CC. I have the rest of the suit made minus the helmet. I had a go at a foam build for the helmet but i am less than pleased with it. Any help would be awesome

 

[Hein B287]

Jup. All pep files still need scaling. What i did was print only the neck seal and test build it. If the head fits through it should fit.

Note. Watch out for bobbleheadedness with scaling.

 

[TillXValhalla]

Thanks for the heads up. I did a bit more research after mini freak out and I did a bit of algebra to get a ratio from a picture to me and went for it with the height just over 24 CM. Got to work realized I didn't have glue so just spent most of the night cutting the pieces out. Hoping to glue tonight .