Reply to thread

Message

Thank you for all this helpful advice, I'll have to test which one of this techniques works best, but I was wondering if there is a way to "modify" the visor? It's Vac formed from thick plastic. Could I maybe heat it up to get it to bend to fit better? Because the main problem I see is that the helmets is too "beaky" so to speak, but I don't want to damage the automotive clear coat it has.

[QUOTE="Helljumper442nd, post: 858157, member: 60070"] Thank you for all this helpful advice, I'll have to test which one of this techniques works best, but I was wondering if there is a way to "modify" the visor? It's Vac formed from thick plastic. Could I maybe heat it up to get it to bend to fit better? Because the main problem I see is that the helmets is too "beaky" so to speak, but I don't want to damage the automotive clear coat it has. [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification