I designed this Bullfrogs emblem so feel free to use.

TheHumongousRat

TheHumongousRat

New Member
You don't need to credit me just go ham.
 

Attachments

  • Bullfrogs_logo.PNG
    Bullfrogs_logo.PNG
    125.1 KB · Views: 73
This thread is more than 11 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

RamenN00dl3
Does anyone want/need a free imperfect vacuum-formed Mark VI visor?
Replies
3
Views
257
RamenN00dl3
RamenN00dl3
MasterChiefProd
Repainting this Halo Reach Mark V helmet that I have to Olive
Replies
8
Views
727
N8TEBB
N8TEBB
M
I need this part HELP!!!
Replies
0
Views
469
MarvisYT
M
RamenN00dl3
What can I use to add some mass to hollow 3D printed armor shells? I'm hoping to add a bit of volume to parts that make sense.
Replies
9
Views
1,516
ReservedTaco
ReservedTaco
CAPEDCRUSADER39
I was thinking of making a Master Chief Helmet, but what should I do when it comes to Tinting the Visor?
Replies
13
Views
491
Nimitz
Nimitz

Similar threads

RamenN00dl3
Does anyone want/need a free imperfect vacuum-formed Mark VI visor?
Replies
3
Views
257
RamenN00dl3
RamenN00dl3
MasterChiefProd
Repainting this Halo Reach Mark V helmet that I have to Olive
Replies
8
Views
727
N8TEBB
N8TEBB
M
I need this part HELP!!!
Replies
0
Views
469
MarvisYT
M
RamenN00dl3
What can I use to add some mass to hollow 3D printed armor shells? I'm hoping to add a bit of volume to parts that make sense.
Replies
9
Views
1,516
ReservedTaco
ReservedTaco
CAPEDCRUSADER39
I was thinking of making a Master Chief Helmet, but what should I do when it comes to Tinting the Visor?
Replies
13
Views
491
Nimitz
Nimitz
Back
Top