Is my head to small for Pepakura?

[Ostrich]

I was cutting out my pepakura pieces and I found this oddity, how am I supposed to cut it?
[attachment=2073:IMG_0009.JPG]

 

[tsau mia]

This is what happens when you print something small. Just cut all along the outside, and then cut on ONLY the solid lines. You're head is not too small for pepakura, just the detail on your (helmet piece?) is small. You're lucky you can still read the numbers.

 

[Ostrich]

This is what happens when you print something small. Just cut all along the outside, and then cut on ONLY the solid lines. You're head is not too small for pepakura, just the detail on your (helmet piece?) is small. You're lucky you can still read the numbers.

Actually I can't read the numbers on some of my pieces.

 

[Sigma LS]

Then make sure you double check your work with the Check Corresponding Face function while you're putting it together.

 

[Robogenisis]

You can always drop the size of the numbers down to 6. Go to "Configuration", then "Edge ID Configuration, and turn the "Font Size" to 6.
You can still read it fine (unless you extremely visually impaired), and it almost never turns into a jumble of numbers.
But if you can't, the "check corresponding face" tool help a lot.

 

[Ostrich]

Okay thanks but where is the corresponding face tool?

 

[AoBfrost]

Right click piece, "select corresponding tool"

Click on any piece, watch it be glowing and highlighted on the model to the left.

 

[SGT Razor]

With scissors.

 

[Robogenisis]

With scissors.

Or an x-acto knife, or a laser cutter, or a robocutter.

 

[Ostrich]

Ok thanks for the help guys! My CQB helmet will be done in no time at all .

 

[AoBfrost]

2-3 days is what most people use to build their helmet.