Reply to thread

Hey, that will be pretty cool! If you are going the 3d printed route, just heads up, Nerdforgedesign/CGTrader took down the Mark Vb Security shoulder model I'm using. Not sure if any other modeler is offering those STLs. Galactic Armory has a nice Emile helmet file.


I'm really liking the N4+ so far. I do wish Orca slicer had a profile for it though. Right now I am using the N4Pro profile just with a bigger bed measurements. Oh, I should add to the post the time it took to print. I'll need to double check before I edit, but I think it was ~13 hours. I just printed the Gungnir pad, and that took around the same time. All that to say, as of right now, totally worth $350.


This thread is more than 9 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top