Reply to thread

Message

As someone in the middle of my full suit build, failure is your best friend to learning. I have failed on the most easiest mistakes, expensive mistakes, and hard to notice mistakes. Even when I finish I'll probably have a mistake or two, but that's what makes it such a great learning experience!!! Don't be afraid to mess up.

For armor Smith what I have come to learn is check your measurements at least twice before printing and save 2 different model sizes incase what you print is to small or to large. Change the variation originally in armor Smith to go both ways. It saves soooo much time I'm looking forward to see what you come up with!!

<blockquote data-quote="MrBones" data-source="post: 843012" data-attributes="member: 55045">As someone in the middle of my full suit build, failure is your best friend to learning. I have failed on the most easiest mistakes, expensive mistakes, and hard to notice mistakes. Even when I finish I&#039;ll probably have a mistake or two, but that&#039;s what makes it such a great learning experience!!!&nbsp; Don&#039;t be afraid to mess up. For armor Smith what I have come to learn is check your measurements at least twice before printing and save 2 different model sizes incase what you print is to small or to large. Change the variation originally in armor Smith to go both ways. It saves soooo much time <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile&nbsp; &nbsp; :)" loading="lazy" data-shortname=":)" /> I&#039;m looking forward to see what you come up with!!</blockquote>

[QUOTE="MrBones, post: 843012, member: 55045"] As someone in the middle of my full suit build, failure is your best friend to learning. I have failed on the most easiest mistakes, expensive mistakes, and hard to notice mistakes. Even when I finish I'll probably have a mistake or two, but that's what makes it such a great learning experience!!! Don't be afraid to mess up. For armor Smith what I have come to learn is check your measurements at least twice before printing and save 2 different model sizes incase what you print is to small or to large. Change the variation originally in armor Smith to go both ways. It saves soooo much time :) I'm looking forward to see what you come up with!! [/QUOTE]

This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification