Reply to thread

So I began the helmet as the first thing I am 3d printing and have already ran into my first problem. The back of the helmet will take 5 days to 7 days to print depending on how I lay it and about 2kg of plastic. Is there any way I can make have a smaller print time with less plastic?


This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top