Reply to thread

Ok so I’ve been working to get things done, and I have run in to a bit of an issue[ATTACH=full]360727[/ATTACH]

This is a part that I’m struggling to make, I age built it already and it doesn’t fit, which is a problem. I have also started to figure out scaling all the other pieces, and I when’t to the forearm and the file on Papakea, is slanted to the point of where I can’t scale it, how do I fix this


Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top