Reply to thread

Message

Ya boi got shoulder.

Continuing from my last post, I drilled an exactly a couple of holes through the bicep into the mount I designed. Then I shoved some M5 heat set inserts into the mount and fastened using M5 socket cap screws and washers.
[ATTACH]349337[/ATTACH][ATTACH]349338[/ATTACH][ATTACH]349339[/ATTACH]

This works as a temporary solution so it can be removed for paint, but also as a way to clamp the two parts together for cement when it’s time to make it permanent.
[ATTACH]349340[/ATTACH]

Also cut up a temporary visor out of a spare PETG sheet and gold window film. It sort of works, and god forbid timing doesn’t work out it’ll serve its purpose, but I’m still married to vacuum forming my visor.
[ATTACH=full]349341[/ATTACH]

[QUOTE="pinoyfiasco, post: 845376, member: 55548"] Ya boi got shoulder. Continuing from my last post, I drilled an exactly a couple of holes through the bicep into the mount I designed. Then I shoved some M5 heat set inserts into the mount and fastened using M5 socket cap screws and washers. [ATTACH]349337[/ATTACH][ATTACH]349338[/ATTACH][ATTACH]349339[/ATTACH] This works as a temporary solution so it can be removed for paint, but also as a way to clamp the two parts together for cement when it’s time to make it permanent. [ATTACH]349340[/ATTACH] Also cut up a temporary visor out of a spare PETG sheet and gold window film. It sort of works, and god forbid timing doesn’t work out it’ll serve its purpose, but I’m still married to vacuum forming my visor. [ATTACH type="full"]349341[/ATTACH] [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification