Reply to thread

A couple more small updates.


In my absent-mindedness I completely forgot about printing a weapon. I opted for Galactic Armory's MA40. I've got everything but the magazine and flashlight printed up. Everything's held together with tape right now, but thanks to the model allowing for a 12" dowel for support it was easy to mock all the pieces up.

[ATTACH=full]353207[/ATTACH]


The Morrigan helmet is all sanded/bondo'd and ready for a final coat of primer so I can catch it up to the rest of my pieces. I'm about ready to start masking for paint chips. In the meantime I decided to dress it up with a camo net like Jun-A266. I need to figure out a way to attach this - very likely magnets will be involved, though I want to fluff it up a little bit too so it helps the neckline flow a little better.


[ATTACH=full]353208[/ATTACH]


Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top