1st Build MJOLNIR Mark VI/Mark VI MOD Armor Build


New Member
Ok, so I've started building my armor about a week ago and, as you can see, I've started with the helmet. My overall build design will be a cross between the Mark VI GEN 2 and Master Chief's Mark VI MOD. I am using 1/2 inch EVA foam and 2mm craft foam. I would like you guys to critique how I'm doing so far, and PLEASE give me some pointers, cause I'm not entirely sure I know what I'm doing.


  • IMG_1332.JPG
    1.2 MB · Views: 19
  • IMG_1331.JPG
    1.6 MB · Views: 16
  • IMG_1330.JPG
    1.3 MB · Views: 19
  • IMG_1329.JPG
    1.4 MB · Views: 18
  • IMG_1328.JPG
    1.3 MB · Views: 17
  • IMG_1327.JPG
    1.3 MB · Views: 17


Jr Member
The tops a bit more rounded but for a first try at a helmet, it’s in pretty good shape. Helmets are the hardest thing to do in this hobby so best of luck!


Well-Known Member
You definitely did better with those vent things at the top of the helmet than I did! What adhesive are you currently using?


New Member
Ok I’ve been making progress, but it’s been slow going due to a mountain of high school work and a severely cut thumb. On a side note, does anyone have recommendations for the lights on the sides of the helmet?


New Member
I'm using bicycle lights, good luck


  • IMG_20211015_102253.jpg
    2.5 MB · Views: 7
  • IMG_20210603_163551.jpg
    4.6 MB · Views: 7
Last edited:

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.