MK V helmet build

Status
Not open for further replies.

crackhead09

RCO
405th Regiment Officer
Hey everyone! This project was actually completed over a year ago, but hey why not share.

So what I did was create a new MK V 3D file from scratch, which hey! that file is now available in the armory section. I did this because I believe the model made by flying squirrel wasn't up to my needs. So here is some pics!
31124077_2202275303349831_950335336137883648_n.jpg 31131797_2202275310016497_4765392491245469696_n.jpg 31166979_2202275240016504_4380638789609979904_n.jpg 31223500_2202275150016513_1968019375839510528_n.jpg 31163156_2202275143349847_2638410281222406144_n.jpg 31131498_2202275156683179_8636032969909207040_n.jpg 31154094_2202275073349854_8016362243857842176_n.jpg

So my file is lacking details and that is intentional. The reason why is because I felt I would have an easier time by glue cut out pieces of polystyrene (from big plastic solo cups look for that recycle code!) and using bondo to add details. The way I make my line details is by cutting some 2mm craft foam and using elmers glue to attach it to the helmet temporarily, looking back spray glue may have worked better. I apply the bondo over and then sand it down until it reach that foam again. I peel the foam away and bam! clean line detail.
 
You do! I may try and get one done for RTX. IF I can find the time to do it.
 
Hey everyone! This project was actually completed over a year ago, but hey why not share.

So what I did was create a new MK V 3D file from scratch, which hey! that file is now available in the armory section. I did this because I believe the model made by flying squirrel wasn't up to my needs. So here is some pics!
View attachment 256202 View attachment 256203 View attachment 256204 View attachment 256205 View attachment 256206 View attachment 256207 View attachment 256208

So my file is lacking details and that is intentional. The reason why is because I felt I would have an easier time by glue cut out pieces of polystyrene (from big plastic solo cups look for that recycle code!) and using bondo to add details. The way I make my line details is by cutting some 2mm craft foam and using elmers glue to attach it to the helmet temporarily, looking back spray glue may have worked better. I apply the bondo over and then sand it down until it reach that foam again. I peel the foam away and bam! clean line detail.


Where in armory can the file be found ? I didnt see it there, could you send me a link ?
 
Status
Not open for further replies.
Back
Top