Reply to thread

[ATTACH=full]319259[/ATTACH][ATTACH=full]319260[/ATTACH]


Build is entirely 3d printed. Not practical, but surprisingly not as heavy as you'd think.

made with Cr-10 took about 4 months to get to this point, so i'm pretty close.

visor is being made by commissioner.


This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top