Reply to thread

Alright! 2nd print is done. Been keeping it small to make sure I like the results and don't waste too much filament. I printed this awesome knife from Galactic Armory and I love how it turned out. It feels really solid and my printer is doing such a beautiful job. Now it's time to move on to the 1st of two handguns that are going to go with the build!


I also took some inspiration from other creators here and have put together a Trello board to help track my progress because just my Google sheet wasn't gonna cut it.


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top