My Halo 1 AR project

Status
Not open for further replies.

kckilla

New Member
so i was Uber bored today and decided to start doing this and i think it is turning out pretty good for a first project i just gotta finish it and clean it up. only worked on it for like a total of like an hour or two

only 2 sheets of half inch foam
IMG_0305.jpg


cutout
IMG_0306.jpg


before details
IMG_0307.jpg


details for front
IMG_0308.jpg


rear detail

IMG_0309.jpg
 

Doom

Well-Known Member
Hey! Dosn't look bad for a start! I like the new approach you took compared to others. There are a few swervy cut out lines that you could have made straighter but its not bad for a start ;-) .

Good Luck!

-Doom
 

kckilla

New Member
ya i know, i kinda put it together real quick and it wasnt the best cutting job i plan on putting puddy on it to smooth it out and make the curved lines on the front grip and the top and maybe fiberglass it up or remake it out of wood because you can sand it and stuff
 
Status
Not open for further replies.
Top