Reply to thread

Message: <blockquote data-quote="S225" data-source="post: 810407" data-attributes="member: 43927"><p>For the shins I found printing small sections to test if a leg would fit to be very useful. Just a few millimeters of whatever opening might give you trouble will let you see if it fits without wasting time or material. I've not looked at the Gen 3 stuff in a slicer but for my MKV I did some tweeking until my foot would fit through the whole thing. Depending in the model it might be necessary to separate a section to allow for this and clamp everything back together as it's worn.</p></blockquote><p></p>

This thread is more than 4 months old.

Your message may be considered spam for the following reasons: