My second attempt at armor


New Member
I'm looking to make a set of mark VII armor from halo infinite and I am very excited to begin, but as I've started I hit a hitch.
Whenever I cut the model with the plane cut tool in meshmixer it is entirely hollow is there a way I can fix this?

I'm using this helmet model by moesizzlac.
Last edited:
There should be a few options that appear when you select plane cut. On the left side of you screen, you should see a drop down for "fill type". There's four options in there. I forget which one is the one that fills the gap you create when cutting but that is indeed the setting to mess with.

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.