Need Help On Installing Visor!

[aeon117]

I am attempting to Pepakura a master chief helmet, and I have a question on how to install a visor.
do you pep the helmet, resin it, then cut out the paper used for visor substitute, and glue in the visor that way? Also Is that how the visor is attached (glued to the inside of the helm)?

Thanks In Advanced,
Aeon

 

[FinnishSpartan]

Just cut out the 'paper visor' it works as a support strut so that the helmet wont collapse during Fiberglassing.
When you are all finished with the helmet (Fiberglassed, sanded, painted) you just hot glue, or epoxy the visor in.

-FSS

 

[aeon117]

Just cut out the 'paper visor' it works as a support strut so that the helmet wont collapse during Fiberglassing.
When you are all finished with the helmet (Fiberglassed, sanded, painted) you just hot glue, or epoxy the visor in.

-FSS

Ok, would I even resin the paper visor? or its just the support, needs no resining?

 

[FinnishSpartan]

Ok, would I even resin the paper visor? or its just the support, needs no resining?

Yes, you can resin it, if you like. But it's not necessary.
Please be sure to read the stickies.

And if you have any more questions wich dont need an open discussio. PM the Q&A team.
(even if you are an older member then me).

-FSS

 

[aeon117]

Yes, you can resin it, if you like. But it's not necessary.
Please be sure to read the stickies.

And if you have any more questions wich dont need an open discussio. PM the Q&A team.
(even if you are an older member then me).

-FSS

noted, although, I couldn't find much info about the installation of pep visors in the stickies.