I have currently finished all the folding on my halo reach default armor build, but the torao is much too wide in terms of from the chest to the back. It is also slightly too large from shoulder to shoulder, but at most that's by an inch. Would anyone have a good solution to this problem or should I start over? If so, what part of my chest should I measure? I measured the height of the torso for this one.
Need Scaling Help
- Thread starter Mich
- Start date
- Status
- Member DIN
- S128
I measured the width of my chest from armpit to armpit and entered it as the width of the reach chest piece, but I also added two inches. It turned out too big. I then repeped it without adding the two inches and it turned out almost perfect! You can check out my progress, the link is in my signature.
- Status
