new at this an need some help

Status
Not open for further replies.

azazel

New Member
hello an thx for any help any one can give to start with

i am totaly new at this stuff an thought it would be cool to do with my sons
i downloaded pepakura viewer 3 an designer 3
i can get the 3 d view to spin in viewer but not in designer any i dear why ???????
what settings do i need to change ?

also i need help with the sizing of the helm for the h3 odst i can not get it to size to 13 in tall ????????????i put it at 331 mm an it wont fit on the paper right for some reason any an all help welcome sry to bother any one but i am new an lost plz plz plz help
 
Welcome to the 405th.
When you say it won't fit on the paper I assume (scary I know) you mean that the pieces aren't aligned on the paper layouts within pep designer. If you scale something, it will change the layout and you will have to reorganize all the pieces to fit within the paper outlines.
As far as the spinning of the model goes??? You should just have to right click on it and move the mouse to make it rotate. Hope this helps and best of luck to you.
 
13in sounds WAY to big for anyone. Im 6' 5" and i only make mine 10.5in. Check your scale.

You can drag and drop the parts to make them fit on each page. Once your model is not so big, it should work just fine.
 
Status
Not open for further replies.
Back
Top