New chest plate

DanielPhoenix27

DanielPhoenix27

New Member
I have successfully printed the ODST Chest piece for my second ODST Cosplay.
I used the Elegoo Neptune 3 Max and have the Chest plate print in 8 pieces.
 

Attachments

  • IMG_4161.jpeg
    IMG_4161.jpeg
    2 MB · Views: 40
  • IMG_4159.mov
    8 MB
  • IMG_4160.jpeg
    IMG_4160.jpeg
    1.9 MB · Views: 37
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Xinal
Hand plate sizing
Replies
2
Views
260
Xinal
Xinal
OffensiveBias
1st Build Where would be best to cut the chest plate and attach buckles? Thank you. Halo 3 Recon on A1 Mini. Pictures attached
Replies
3
Views
387
Negativecacti
Negativecacti
DanielPhoenix27
New ODST armor
Replies
2
Views
464
DanielPhoenix27
DanielPhoenix27
vdcdv
3D Printed chest rigging
Replies
3
Views
734
Hyprfixate
Hyprfixate
jbowling1775
1st Build New toy
Replies
0
Views
226
jbowling1775
jbowling1775

Similar threads

Xinal
Hand plate sizing
Replies
2
Views
260
Xinal
Xinal
OffensiveBias
1st Build Where would be best to cut the chest plate and attach buckles? Thank you. Halo 3 Recon on A1 Mini. Pictures attached
Replies
3
Views
387
Negativecacti
Negativecacti
DanielPhoenix27
New ODST armor
Replies
2
Views
464
DanielPhoenix27
DanielPhoenix27
vdcdv
3D Printed chest rigging
Replies
3
Views
734
Hyprfixate
Hyprfixate
jbowling1775
1st Build New toy
Replies
0
Views
226
jbowling1775
jbowling1775
Back
Top