1st Build NOBLE 1 and NOBLE 2


Carter7236

New Member
I've been in the 501st since 09, so costuming isn't new, but this is our first Halo Reach costumes.
We started the build in foam several yrs ago, however the cat loved to chew on them, so they were trashed, and now that we have a couple of Ender 3's and a couple CR 10's, the Reach goal has been revived.
I bought my Carter helmet (resin) from one of the Impact Prop guys, on the first go round and we have a resin magnum picked up from a friend in Texas.
For Noble 1 , we have printed both biceps, hand plates and both shoulder armor.
Noble 2 , we have the left bicep, hand plates and belt pieces.
 

Attachments

  • 20210519_143642(0).jpg
    20210519_143642(0).jpg
    1.4 MB · Views: 13
  • 20210606_140504.jpg
    20210606_140504.jpg
    294.7 KB · Views: 13
  • 20210615_103931.jpg
    20210615_103931.jpg
    1.2 MB · Views: 6
  • 20210615_103952.jpg
    20210615_103952.jpg
    1.5 MB · Views: 13

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top