ODST - 2nd Build

Thread starter Spinostroyer1
Start date Oct 29, 2025

Spinostroyer1

New Member

Oct 29, 2025

Hello There! I've lurked around the forum a bit but I figured better late than never to get properly involved. at the moment I'm doing EVA foam armor, like you see below with my ODST, but I do wish to at some point branch out into 3d printing But everything you see here is all made completely out of EVA foam! this project took me about two and a half months to do and was a blast. And I hope what I've learned from this project will carry over to future projects. The paint scheme of my ODST is a mixture of the ones you see on the Ark during Halo 3, and a bit of a custom camo scheme!

This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.